OrangeRx V2 Stabilizer - Delta Setup |
|
In July 2021, YouTube set all unlisted videos uploaded before 2017 to private (unless the channel owner had opted out). In the weeks leading up to this change, Archive Team archived many pre-2017 unlisted YouTube videos. If this video was uploaded before 2017 and has gone private, there is a chance that a 360p archived version can be viewed on archive.org via the site's Wayback Machine as follows: 1. Enter the YouTube URL in the Wayback Machine form or click on the following link: https://web.archive.org/web/20210000000000*/https://www.youtube.com/watch?v=LgqJlD9TDVc 2. Right-click on a blue entry in July in the calendar. 3. Click 'Copy link address'. 4. Paste the copied link address into your web browser's address bar and press enter.
Description: Link to stabilizer: http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp%3Fidproduct%3D28456%26aff%3D238467 How to setup a delta wing with the OrangeRx V2 Stabilizer unit. This unit has onboard delta mixing, so start off by disabling any delta mixing that you have programmed. - Rx: Using male-to-male servo wires, hook up the Elevator and Aileron controls from your Rx to the stabilization unit's Ele and Aile ports - Stabilizer: Plug in your right control surface to Ele and your left control surface to Ail-L (right and left control surfaces as you look at the plane from the nose). Then flip the dip switches to the left for Ail, Ele, and Delta. [if your servos are lying down (mine are upright), you need to leave both ELE and AIL L set to NORMAL, rather than reversing them - thanks Flash5Cartooning!'> - Tx: Reverse your elevator output. That's it! Hope this helps. Let me know what questions you have. (I think that this should work for all transmitters, but I am using a Dx7se and can't verify this!) 
|
